Pull out the dipstick again and check the oil level on it. Pull out the dipstick, wipe it clean, and insert it again. (Manual transmission equipped models only.) Park your Subaru on a level surface and stop the engine. If it is below that range, add fluid up to the upper level. Important: If you don't have time to warm up the automatic transmission, check to see that the fluid level is between the lower level and the upper level on the "COLD" side. If it is below the lower level on the "HOT" side, add the recommended automatic transmission fluid up to the upper level. Pull out the dipstick and check the fluid level on the gauge. Then shift it in the "P" position, and run the engine at idling speed. Shift the selector level in each position.
Park on a level surface and set the parking brake. (Automatic transmission equipped models only.) Drive several miles to raise the temperature of your car's transmission fluid up to normal operating temperatures (140 to 176 degrees is normal). Use of other coolants may result in corrosion.
#Brake fluid flush cost 2002 subaru forester manual
Important: Use the coolant recommended in your Owner's Manual only. After filling the reserve tank and the radiator, reinstall the caps and check that the rubber gasket inside the radiator cap is in the proper position. If the reserve tank is empty, remove the radiator cap (Do not open when the radiator is hot!) and refill as required. If the level is close to or lower than the "LOW" mark, add coolant up to the "FULL" mark. Check your car's coolant level on the outside of the reservoir while the engine is cool. Important: Use only engine oil with the grade and viscosity recommended in your Owner's Manual. If it is below the lower level, add oil to bring it up to the upper level. Pull out the dipstick, wipe it clean, and insert it again until it stops. Park your Subaru on a level surface and stop the engine. Use your Owner's Manual as a guide for more details and to locate specific engine parts.
Take care not to spill any engine oil, engine coolant, brake fluid or any other fluid on hot engine components. Properly maintaining your car's fluid levels is an easy way to help ensure that your Subaru runs smoothly between service visits.īefore checking, always stop the engine, remove the key from the ignition switch, set the parking brake and let the engine cool down completely.
0 kommentar(er)
